Components
COMPONENTS
ILLUSTRATION
*1 |
CLOCK ASSEMBLY |
*2 |
INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY |
Inspection
INSPECTION
PROCEDURE
1. INSPECT AIRBAG CUT-OFF INDICATOR LIGHT (CLOCK ASSEMBLY)
(a) Check illumination.
(1) Apply battery voltage to the airbag cut-off indicator light (clock assembly) and check that it illuminates. OK:
If the result is not as specified, replace the airbag cut-off indicator light (clock assembly). |
|
Removal
REMOVAL
CAUTION / NOTICE / HINT
Click here
Toyota CH-R Service Manual > Airbag System: Side Airbag Sensor Assembly No.2 Lost Communication (LH) (B163B/86,B163C/86)
DESCRIPTION
The side collision sensor LH circuit (bus 2) consists of the airbag sensor assembly
and floor side airbag sensor LH.
The floor side airbag sensor LH detects impacts to the vehicle and sends signals
to the airbag sensor assembly to determine if the airbags and pretensioners should
...
Toyota CH-R Service Manual > Continuously Variable Transaxle System: Acceleration Sensor Learning Value (P1589)
DESCRIPTION
The ECM stores DTC P1589 if deceleration sensor zero point calibration is not
performed or failed after system components such as the ECM are replaced.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
MIL
Me ...