CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
CUSTOMER PROBLEM ANALYSIS |
(a) Interview the customer to confirm the trouble.
Click here
|
3. |
INSPECT BATTERY VOLTAGE |
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
4. |
INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Using the Techstream, check if the CAN communication system is functioning normally.
Click here
Result |
Proceed to |
---|---|
CAN DTCs are not output |
A |
CAN DTCs are output |
B |
B | ![]() |
GO TO CAN COMMUNICATION SYSTEM |
|
5. |
CHECK COMBINATION METER ASSEMBLY |
(a) Check the operation of the speedometer and shift indicator on the combination meter assembly.
OK:
The speedometer and shift indicator on the combination meter assembly operate normally.
NG | ![]() |
GO TO METER / GAUGE SYSTEM |
|
6. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
Result |
Proceed to |
---|---|
Fault is not listed in problem symptoms table |
A |
Fault is listed in problem symptoms table |
B |
B | ![]() |
GO TO STEP 8 |
|
7. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Data List / Active Test
Click here
(b) Terminals of ECU
Click here
(c) On-vehicle Inspection
Click here
|
8. |
REPAIR OR REPLACE |
|
9. |
CONFIRMATION TEST |
NEXT | ![]() |
END |
Toyota CH-R Service Manual > Generator: Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL GENERATOR DRIVE END FRAME BEARING
(a) Using SST and a press, install a new generator drive end frame bearing.
SST: 09950-60010
09951-00470
SST: 09950-70010
09951-07100
(b) Fit the ta ...
Toyota CH-R Service Manual > Blower Unit(for Valeo Made): Components
COMPONENTS
ILLUSTRATION
*A
for Dual Type
*B
for Single Type
*C
w/ PTC Heater
-
-
*1
BLOWER ASSEMBLY
*2
NO. 2 AIR DUCT
*3
NO. ...