Toyota CH-R Service Manual: Customize Parameters

CUSTOMIZE PARAMETERS

NOTICE:

  • When the customer requests a change in a function, first make sure that the function can be customized.
  • Be sure to make a note of the current settings before customizing.
  • When troubleshooting a function, first make sure that the function is set to the default setting.
  • These buzzers should be ON for safe driving. Perform this procedure only if it is necessary to set the buzzer to OFF (disabled).

Customizing with the Techstream

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Customize Setting / Warning.

(e) Select the setting by referring to the table below.

Warning

Tester Display

Description

Default

Setting

ECU

Driver Side Seatbelt Warning Buzzer

Function to sound the driver seat belt warning buzzer

ON

0:OFF,1:ON

Combination meter assembly

Front Passenger Side Seatbelt Warning Buzzer

Function to sound the front passenger seat belt warning buzzer

ON

0:OFF,1:ON

Combination meter assembly

Rear Seatbelt Warning Buzzer

Function to sound the rear seat belt warning buzzer*

ON

0:OFF,1:ON

Combination meter assembly

  • *: Although the item is displayed on the Techstream, it is not applicable to this vehicle.

HINT:

This setting is only valid when the vehicle is driven at 20 km/h (12 mph) or more.

    System Diagram
    SYSTEM DIAGRAM ...

    How To Proceed With Troubleshooting
    CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the seat belt warning system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROU ...

    Other materials:

    Toyota CH-R Service Manual > Can Communication System: Check Bus 5 Line for Short to GND
    DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 15 (CA5H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 16 (CA5L) of the central gateway ECU (network gateway ECU) and ...

    Toyota CH-R Service Manual > Hood: Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE HOOD SIDE PANEL LH (a) Using a clip remover, disengage the clips to remove the hood side panel LH. 2. REMOVE HOOD SIDE PANEL RH HINT: Use the same procedure as for the LH side. 3. REMOVE HOOD INSULA ...

    © 2017-2021 Copyright www.tochr.net
    0.0265