BODY
TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
(a) If necessary, tighten the bolts and nuts on the chassis parts listed below.
(b) If necessary, tighten the bolts and nuts on the body parts listed below.
REPLACE AIR CONDITIONING FILTER
(a) Remove the air conditioning filter.
Click here
Click here
(b) Visually inspect the surface of the air conditioning filter.
(c) If the air conditioning filter is contaminated with foreign matter, clean or replace it according to the maintenance schedule.
NOTICE:
Some filters are not able to be cleaned.
ROAD TEST
(a) Check the engine and chassis for abnormal noises.
(b) Check that the vehicle does not wander or pull to one side.
(c) Check that the brakes work properly and do not drag.
(d) Bed-in the parking brake pads.
BODY INSPECTION
(a) Check the body exterior for dents, scratches and rust.
(b) Check the underbody for rust and damage.
If necessary, replace any damaged parts or repair any damaged areas.
FINAL INSPECTION
(a) Check the operation of the body parts.
(1) Hood
(2) Front and rear doors
(3) Back door
Door lock operates properly.
(4) Seats
(5) Be sure to deliver a clean car. Make sure to check the following:
Chassis
Headlight BulbToyota CH-R Service Manual > Pre-collision System: System Diagram
SYSTEM DIAGRAM
Communication Table
Sender
Receiver
Signal
Line
Millimeter Wave Radar Sensor Assembly
Skid Control ECU (Brake Actuator Assembly)
Brake assist standby signal
Pre-collision brake ope ...
Toyota CH-R Service Manual > Hazard Warning Switch: Removal
REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
Click here
2. REMOVE INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY
Click here
3. REMOVE INSTRUMENT PANEL CENTER REGISTER ASSEMBLY
Click here
4. REMOVE HAZARD WARNING SIGNAL SWITCH A ...