Components
COMPONENTS
ILLUSTRATION
*1 |
NO. 1 HEADLIGHT BULB |
- |
- |
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE NO. 1 HEADLIGHT BULB
(a) Disconnect the connector. |
|
(b) Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration, and remove it.
![]() |
Remove in this Direction |
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL NO. 1 HEADLIGHT BULB
(a) Turn the front turn signal light socket with the front turn signal light bulb as shown in the illustration to install them as a unit.
![]() |
Install in this Direction |
(b) Connect the connector.
Toyota CH-R Service Manual > Airbag System: Short in Passenger Side Front Seat Cushion Squib Circuit (B1875/67-B1878/67)
DESCRIPTION
The passenger side front seat cushion squib circuit consists of the airbag sensor
assembly and front seat cushion airbag assembly RH.
The airbag sensor assembly uses this circuit to deploy the airbag when deployment
conditions are met.
These DTCs are stored when a malfunction is d ...
Toyota CH-R Service Manual > Vehicle Stability Control System: Open in Front Speed Sensor RH (C1330-C1467)
DESCRIPTION
Each speed sensor detects wheel speed and sends signals to the skid control ECU
(brake actuator assembly). These signals are used by the ABS.
HINT:
The output voltage values shown below are for when the vehicle wire harnesses
are connected to the skid control ECU (brake actuator a ...