Toyota CH-R Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:

  • Use the same procedure for the driver side and front passenger side.
  • The procedure listed below is for the driver side.

PROCEDURE

1. INSTALL FRONT SEATBACK HEATER ASSEMBLY

(a) Install the front seatback heater assembly to the separate type front seatback cover with 16 new tag pins.

2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER

Click here

3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Click here

4. INSTALL FRONT SEAT HEADREST SUPPORT

Click here

5. INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Click here

6. INSTALL FRONT SEAT INNER CUSHION SHIELD (for Driver Side)

Click here

7. INSTALL FRONT SEAT CUSHION SHIELD (for Driver Side)

Click here

8. INSTALL SEAT ADJUSTER COVER CAP (w/ Vertical Adjuster)

Click here

9. INSTALL FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)

Click here

10. INSTALL FRONT SEAT CUSHION SHIELD (for Front Passenger Side)

Click here

11. INSTALL RECLINING ADJUSTER RELEASE HANDLE

Click here

12. INSTALL RECLINING HINGE OUTER COVER

Click here

13. INSTALL VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)

Click here

14. CONNECT SEPARATE TYPE FRONT SEATBACK COVER

Click here

15. INSTALL FRONT SEAT ASSEMBLY

Click here

    Inspection
    INSPECTION PROCEDURE 1. INSPECT FRONT SEATBACK HEATER ASSEMBLY LH (a) for TMC Made: (1) Check the resistance. Measure the resistance according to the value(s) in the tab ...

    Lumbar Support Adjuster Assembly
    ...

    Other materials:

    Toyota CH-R Service Manual > Can Communication System: Check Bus 2 Line for Short to GND
    DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 18 (CA4H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 17 (CA4L) of the central gateway ECU (network gateway ECU) and ...

    Toyota CH-R Service Manual > Rear View Monitor System: Diagnosis System
    DIAGNOSIS SYSTEM DESCRIPTION (a) Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the rear view monitor system seems to be malfunctioning, use the Techstream to check for malfunctions and to perform repairs. CHECK DLC3 (a) Check the DLC3. ...

    © 2017-2020 Copyright www.tochr.net
    0.018