REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE QUARTER PILLAR COVER SUB-ASSEMBLY
HINT:
When removing the quarter pillar cover sub-assembly, heat the vehicle body and quarter pillar cover sub-assembly using a heat light.
Heating Temperature
Item |
Temperature |
---|---|
Quarter Pillar Cover Sub-assembly |
20 to 30°C (68 to 86°F) |
CAUTION:
*a |
Heated Part |
*b |
Heat Light |
NOTICE:
Do not heat the vehicle body or quarter pillar cover sub-assembly excessively.
(a) Using a heat light, heat the quarter pillar cover sub-assembly.
(b) Disengage the clips and guide to remove the quarter pillar cover sub-assembly as shown in the illustration.
*a |
Double-sided Tape |
![]() |
Remove in this Direction |
HINT:
When removing the quarter pillar cover sub-assembly, peel off the double-sided tape.
Toyota CH-R Service Manual > Vehicle Stability Control System: TRAC does not Operate
DESCRIPTION
When ABS, TRAC or VSC is operating, the skid control ECU (brake actuator assembly)
blinks the slip indicator light to inform the driver that slippage occurred.
When in VSC off mode, or TRAC and VSC are disabled, the multi-information display
in the combination meter assembly displa ...
Toyota CH-R Service Manual > Black Out Tape(for Rear Door): Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. REPAIR INSTRUCTION
Click here
2. INSTALL REAR DOOR OUTSIDE STRIPE
(a) Refer to the illustration to position a new rear ...