Components
COMPONENTS
ILLUSTRATION
|
*1 |
FOG LIGHT BULB |
*2 |
FRONT FENDER LINER |
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. SEPARATE FRONT FENDER LINER
(a) Remove the 2 screws and clip and fold back part of the front fender liner.
2. REMOVE FOG LIGHT BULB
|
(a) Disconnect the connector. |
|
(b) Turn the fog light bulb as shown in the illustration to remove it.
|
Remove in this Direction |
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL FRONT TURN SIGNAL LIGHT BULB
(a) Turn the fog light bulb as shown in the illustration to install it.
|
Install in this Direction |
(b) Connect the connector.
2. INSTALL FRONT FENDER LINER
(a) Install the front fender liner with the clip and 2 screws.
Brake FluidToyota CH-R Service Manual > Pre-collision System: Terminals Of Ecu
TERMINALS OF ECU
CHECK MILLIMETER WAVE RADAR SENSOR
(a) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
If the result is not as specified, there may be a malfunction on the wire harness
side.
Terminal No. (Symbol)
Wiring Color
...
Toyota CH-R Service Manual > Tire And Wheel System: How To Proceed With Troubleshooting
PROCEDURE
1.
CHECK TIRE AND WHEEL SYSTEM
DIAGNOSIS OF IRREGULAR TIRE WEAR
GO TO STEP 11
DIAGNOSIS OF TIRE VIBRATION
2.
TIGHTEN WHEEL NUTS
...