INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
(a) Using a T30 "TORX" socket wrench, install the rear door courtesy light switch assembly with the screw.
|
Install in this Direction |
Torque:
6.0 N·m {61 kgf·cm, 53 in·lbf}
(b) Connect the connector.
2. INSTALL REAR SEAT SIDE GARNISH (w/ Rear Seat Side Airbag)
Click here
3. INSTALL REAR SEAT SIDE GARNISH (w/o Rear Seat Side Airbag)
Click here
4. INSTALL REAR PILLAR COVER (w/ Rear Seat Side Airbag)
Click here
5. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY
Click here
6. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
|
(a) Connect the rear door opening trim weatherstrip to the area shown in the illustration. |
|
7. INSTALL REAR DOOR SCUFF PLATE (w/ Rear Seat Side Airbag)
Click here
8. INSTALL REAR DOOR SCUFF PLATE (w/o Rear Seat Side Airbag)
Click here
9. INSTALL REAR SEAT ASSEMBLY
Click here
Removal
Room LightToyota CH-R Service Manual > Front Door Speaker: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY
(a) Engage the claw and guide to temporarily install the front No. 1
spea ...
Toyota CH-R Service Manual > Vehicle Stability Control System: Stop Light Switch OFF Stuck Malfunction (C1426)
DESCRIPTION
The skid control ECU (brake actuator assembly) receives stop light switch signals
and uses them to determine whether or not the brakes are applied.
The skid control ECU (brake actuator assembly) has a detection circuit that it
uses to detect a short in the stop light input line or ...