INSPECTION
PROCEDURE
1. INSPECT MAP LIGHT ASSEMBLY
|
(a) Check the map light. (1) Apply battery voltage to the map light assembly and check that the map light comes on. OK:
If the result is not as specified, replace the map light bulb or map light assembly. |
|
(b) Check the door switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Switch Condition |
Specified Condition |
|---|---|---|
|
10 (DOOR) - 4 (RLMP) |
Door switch on |
Below 1 Ω |
|
Door switch off |
10 kΩ or higher |
If the result is not as specified, replace the map light assembly.
(c) Check the switch illumination.
(1) Apply battery voltage to the map light assembly and check that the illumination comes on.
OK:
|
Battery Connection |
Specified Condition |
|---|---|
|
Battery positive (+) → 2 (ILLB) Battery negative (-) → 3 (GND) |
Illumination comes on |
If the result is not as specified, replace the map light assembly.
Removal
InstallationToyota CH-R Service Manual > Power Steering System: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Power Steering System
DTC No.
Detection Item
DTC Detection Condition
Warning Indicate
Return-to-normal Condition
Note
Link
C1511
Torque Sensor1
Torque s ...
Toyota CH-R Service Manual > Rear Bumper: Components
COMPONENTS
ILLUSTRATION
*1
QUARTER OUTSIDE MOULDING LH
*2
QUARTER OUTSIDE MOULDING RH
*3
REAR BUMPER ASSEMBLY
*4
REAR BUMPER SIDE SEAL LH
*5
REAR BUMPER SIDE SEAL RH
...