COMPONENTS
ILLUSTRATION
|
*1 |
QUARTER OUTSIDE MOULDING LH |
*2 |
QUARTER OUTSIDE MOULDING RH |
|
*3 |
REAR BUMPER ASSEMBLY |
*4 |
REAR BUMPER SIDE SEAL LH |
|
*5 |
REAR BUMPER SIDE SEAL RH |
- |
ILLUSTRATION
|
*1 |
FOG LIGHT BRACKET |
*2 |
NO. 1 REAR BUMPER PLATE |
|
*3 |
REAR BUMPER CENTER GUARD |
*4 |
REAR BUMPER PAD LH |
|
*5 |
REAR BUMPER PAD RH |
*6 |
REAR BUMPER PLATE LH |
|
*7 |
REAR BUMPER PLATE RH |
*8 |
REAR BUMPER SIDE STAY LH |
|
*9 |
REAR BUMPER SIDE STAY RH |
*10 |
REAR BUMPER UPPER COVER LH |
|
*11 |
REAR BUMPER UPPER COVER RH |
*12 |
REFLEX REFLECTOR ASSEMBLY LH |
|
*13 |
REFLEX REFLECTOR ASSEMBLY RH |
*14 |
OUTSIDE MOULDING RETAINER |
|
*15 |
REAR BUMPER COVER |
- |
- |
|
● |
Non-reusable part |
- |
- |
ILLUSTRATION
|
*1 |
REAR BUMPER SIDE RETAINER LH |
*2 |
REAR BUMPER SIDE RETAINER RH |
|
*3 |
REAR BUMPER UPPER RETAINER LH |
*4 |
REAR BUMPER UPPER RETAINER RH |
|
*5 |
REAR COMBINATION LIGHT COVER LH |
*6 |
REAR COMBINATION LIGHT COVER RH |
|
*7 |
REAR COMBINATION LIGHT LH |
*8 |
REAR COMBINATION LIGHT RH |
ILLUSTRATION
|
*A |
for USA and Canada |
*B |
except USA and Canada |
|
*1 |
REAR BUMPER REINFORCEMENT SUB-ASSEMBLY |
*2 |
REAR BUMPER ARM SUB-ASSEMBLY LH |
|
*3 |
REAR BUMPER ARM SUB-ASSEMBLY RH |
*4 |
REAR BUMPER PAD |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
Rear Bumper
RemovalToyota CH-R Service Manual > Air Conditioning System(for Automatic Air Conditioning System With Top-mounted
Air Conditioner Pressure Sensor): Compressor Solenoid Circuit (B1451)
DESCRIPTION
In this circuit, the compressor with pulley assembly (compressor solenoid) receives
a refrigerant compression demand signal from the air conditioning amplifier assembly.
Based on this signal, the compressor with pulley assembly (compressor solenoid)
changes the amount of compressor ...
Toyota CH-R Service Manual > Navigation System: Radio Receiver Power Source Circuit
DESCRIPTION
This is the power source circuit to operate the radio and display receiver assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following
procedure.
PROCEDURE
1.
CHECK HARNES ...