Toyota CH-R Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE REAR BUMPER SIDE SEAL LH

(a) Remove the 7 clips and rear bumper side seal LH.

2. REMOVE REAR BUMPER SIDE SEAL RH

HINT:

Use the same procedure as for the LH side.

3. SEPARATE QUARTER OUTSIDE MOULDING LH

(a) Apply protective tape around the quarter outside moulding LH.

Protective Tape

(b) Remove the 2 screws.

(c) Disengage the claws by pushing the area indicated by the arrow in the illustration with a finger.

	Place Hand Here
	Remove in this Direction

NOTICE:

To avoid damaging the claws, do not forcibly pull the quarter outside moulding LH.

(d) Disengage the clip to disconnect the quarter outside moulding LH from the rear bumper assembly.

4. SEPARATE QUARTER OUTSIDE MOULDING RH

HINT:

Use the same procedure as for the LH side.

5. REMOVE REAR BUMPER ASSEMBLY

(a) Apply protective tape around the rear bumper assembly.

Protective Tape

HINT:

Use the same procedure for the RH side and LH side.

(b) Remove the 6 clips.

(c) Using a screwdriver with its tip wrapped in protective tape, disengage the claws to open the rear bumper upper cover LH. HINT: Use the same procedure for the RH side and LH side.

*a Protective Tape

(d) Remove the 2 bolts.

(e) Disengage the claws as shown in the illustration.

Remove in this Direction

HINT:

Use the same procedure for the RH side and LH side.

(f) Disengage the claws to remove the rear bumper assembly as shown in the illustration.

Remove in this Direction