INSTALLATION
PROCEDURE
1. INSTALL MAP LIGHT ASSEMBLY
(a) Connect each connector.
(b) Engage the guide and clips to install the map light assembly as shown in the illustration.
|
Install in this Direction (1) |
|
Install in this Direction (2) |
2. INSTALL MAP LIGHT BULB
Click here
3. INSTALL NO. 1 MAP LIGHT LENS
(a) Engage the guide and claws to install the No. 1 map light lens as shown in the illustration.
|
Install in this Direction (1) |
|
Install in this Direction (2) |
InspectionToyota CH-R Service Manual > Rear Shock Absorber: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. INSTALL REAR SUSPENSION SUPPORT ASSEMBLY
(a) Secure the rear suspension support assembly in a vise using aluminum plates.
N ...
Toyota CH-R Service Manual > Airbag System: TC and CG Terminal Circuit
DESCRIPTION
DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking of the SRS warning light.
HINT:
When multiple warning lights in the combination meter blink continuously,
a short to ground in the wiring or an ECU connected to terminal T ...