Toyota CH-R Service Manual: Diagnosis System

DIAGNOSIS SYSTEM

DESCRIPTION

(a) Lighting system data can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.

CHECK DLC3

(a) Check the DLC3.

Click here

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

    Data List / Active Test
    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when de ...

    IG Signal Circuit
    DESCRIPTION This circuit detects the ignition switch ON or off condition, and sends it to the main body ECU (multiplex network body ECU). WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: ...

    Other materials:

    Toyota CH-R Service Manual > Back Door Outside Garnish: Removal
    REMOVAL PROCEDURE 1. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim) Click here 2. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) Click here 3. REMOVE BACK DOOR TRIM UPPER PANEL ASSEMBLY Click here 4. REMOVE BACK DOOR SIDE GARNISH LH Click here 5. R ...

    Toyota CH-R Service Manual > Compressor(for Denso Made): Installation
    INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL (a) When replacing the compressor with pulley assembly with a new one, gradually discharge the refrigerant gas from the service valve. Then drain the following amount of oil from the new compressor with pulley assembly before ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0112