Toyota CH-R Service Manual: Inspection

Toyota CH-R Service Manual / Lighting (int) / Ambient Light / Inspection

INSPECTION

PROCEDURE

1. INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY LH

(a) Check that the LED illuminates.

(1) Apply battery voltage to the No. 1 interior illumination light assembly LH and check that the LED illuminates.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → 1 (+)

Battery negative (-) → 2 (-)

LED illuminates

If the result is not as specified, replace the No. 1 interior illumination light assembly LH.

*a

Component without harness connected

(No. 1 Interior Illumination Light Assembly LH)

2. INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY RH

(a) Check that the LED illuminates.

(1) Apply battery voltage to the No. 1 interior illumination light assembly RH and check that the LED illuminates.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → 1 (+)

Battery negative (-) → 2 (-)

LED illuminates

If the result is not as specified, replace the No. 1 interior illumination light assembly RH.

*a

Component without harness connected

(No. 1 Interior Illumination Light Assembly RH)
    Removal
    REMOVAL PROCEDURE 1. REMOVE FRONT ARMREST BASE UPPER PANEL (for Driver Side) Click here 2. REMOVE FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side) Click here 3. REMOVE FRONT DOOR IN ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY (a) Engage the claws to install the No. 1 interior illumination light assembly. ...

    Other materials:

    Toyota CH-R Service Manual > Wireless Door Lock Control System(w/ Smart Key System): Precaution
    PRECAUTION PRECAUTIONS WHEN USING Techstream (a) When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then se ...

    Toyota CH-R Service Manual > Vehicle Stability Control System: Open in ABS Solenoid Relay Circuit (C146E)
    DESCRIPTION The ABS solenoid relay is built into the skid control ECU in the brake actuator assembly. The ABS solenoid relay supplies power to the ABS and TRAC solenoids. The skid control ECU detects a solenoid relay malfunction by performing a self check and relay operation check. ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0078