Toyota CH-R Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY

(a) Engage the claws to install the No. 1 interior illumination light assembly.

*a

Clamp

*b

Guide

(b) Install the 2 screws.

(c) Engage the guides and clamp to connect the wire harness.

2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Click here

3. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

Click here

4. INSTALL FRONT ARMREST BASE UPPER PANEL (for Driver Side)

Click here

5. INSTALL FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Click here

    Inspection
    INSPECTION PROCEDURE 1. INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY LH (a) Check that the LED illuminates. (1) Apply battery voltage to the No. 1 interior illumination light as ...

    Back Door Courtesy Switch
    ...

    Other materials:

    Toyota CH-R Service Manual > Windshield Deicer System: How To Proceed With Troubleshooting
    CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the windshield deicer system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

    Toyota CH-R Service Manual > Continuously Variable Transaxle System: Torque Converter Clutch Solenoid Circuit Low (P2769,P2770)
    DESCRIPTION Based on the signal received by the shift solenoid valve SL, the ECM uses the shift solenoid valve SLU to control the lock-up clutch pressure. If there is an open or short in the shift solenoid valve SL circuit, the ECM stops sending current to the defective shift solenoid valve. ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0124