Toyota CH-R Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT ARMREST BASE UPPER PANEL (for Driver Side)

Click here

2. REMOVE FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Click here

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

Click here

4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Click here

5. REMOVE NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY

*a

Clamp

*b

Guide

(a) Using a clip remover, disengage the clamp and guides to disconnect the wire harness.

(b) Remove the 2 screws.

(c) Disengage the claws to remove the No. 1 interior illumination light assembly.

    Components
    COMPONENTS ILLUSTRATION *A for Driver Side *B for Front Passenger Side *1 FRONT ARMREST BASE UPPER PANEL *2 ...

    Inspection
    INSPECTION PROCEDURE 1. INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY LH (a) Check that the LED illuminates. (1) Apply battery voltage to the No. 1 interior illumination light as ...

    Other materials:

    Toyota CH-R Service Manual > Vehicle Stability Control System: Zero Point Calibration of Acceleration Sensor Undone (C1336)
    DESCRIPTION The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via CAN communication. The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle's condition using 2 circu ...

    Toyota CH-R Owners Manual > Driving procedures: Parking brake
    A selections can be made as desired from the following modes. Automatic mode The parking brake is set or released automatically according to shift lever operation. Even when in automatic mode, the parking brake can be set and released manually. Turns automatic mode on (while the vehicle is ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0093