Toyota CH-R Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL AUTOMATIC LIGHT CONTROL SENSOR

(a) Engage the claws to install the automatic light control sensor.

(b) Connect the connector.

2. INSTALL DEFROSTER NOZZLE ASSEMBLY

Click here

3. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here

    Inspection
    INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Check the wire harness. (1) Disconnect the automatic light control sensor (G1). (2) Measure the voltage according to ...

    Interior Panels / Trim
    ...

    Other materials:

    Toyota CH-R Service Manual > Can Communication System: Check Bus 3 Line for Short to GND
    DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 6 (CA3H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 21 (CA3L) of the central gateway ECU (network gateway ECU) and ...

    Toyota CH-R Service Manual > Rear Center Seat Outer Belt Assembly: On-vehicle Inspection
    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to correctly follow the removal and installation procedures for the rear center seat outer belt assembly. PROCEDURE 1. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision) (a) Visually check for ...

    © 2017-2019 Copyright www.tochr.net
    0.0155