On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT PTC HEATER RELAY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
|
*a |
Component without harness connected (PTC HTR NO. 1) |
*b |
Component without harness connected (PTC HTR NO. 2) |
|
*c |
Component without harness connected (PTC HTR NO. 3) |
- |
- |
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
3 - 5 |
Battery voltage not applied between terminals 1 and 2 |
10 kΩ or higher |
|
3 - 5 |
Battery voltage applied between terminals 1 and 2 |
Below 1 Ω |
If the result is not as specified, replace the PTC heater relay.
Replacement
Room Temperature SensorToyota CH-R Service Manual > Inner Rear View Mirror: Installation
INSTALLATION
PROCEDURE
1. INSTALL INNER REAR VIEW MIRROR ASSEMBLY (w/o Pre-collision System)
(a) Install the inner rear view mirror assembly as shown in the illustration.
Install in this Direction
(b) Using a T20 "TORX" socket wrench, install the screw.
...
Toyota CH-R Service Manual > Airbag System: Diagnosis System
DIAGNOSIS SYSTEM
CHECK DLC3
(a) Check the DLC3.
Click here
FUNCTION OF SRS WARNING LIGHT
(a) Primary check
(1) Turn the ignition switch off. Wait for at least 2 seconds, then turn the
ignition switch ON. The SRS warning light comes on for approximately 6 seconds and
diagnosis of the airb ...