INITIALIZATION
INITIALIZATION SERVO MOTOR
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch ON.
(d) Press the A/C OFF switch.
(e) Turn the Techstream on.
(f) Enter the following menus: Body Electrical / Air Conditioner / Utility / Servomotor Initialization.
(g) According to the Techstream display, perform servo motor initialization.
Body Electrical > Air Conditioner > Utility|
Tester Display |
|---|
|
Servomotor Initialization |
HINT:
During initialization, the AUTO indicator light comes on, and then goes off when initialization has finished.
(h) According to the Techstream display, select the Exit switch to finish initialization.
How To Proceed With Troubleshooting
Problem Symptoms TableToyota CH-R Service Manual > Continuously Variable Transaxle Fluid: Adjustment
ADJUSTMENT
PROCEDURE
1. PRECAUTIONS AND WORK DESCRIPTION
(a) The K114 continuously variable transaxle assembly does not have an oil filler
tube or oil level gauge. When adding fluid, add fluid through the refill hole in
the continuously variable transaxle assembly. The fluid level can be adju ...
Toyota CH-R Service Manual > Airbag System: Short in Curtain Shield Squib LH Circuit (B1835/58-B1838/58)
DESCRIPTION
The curtain shield squib LH circuit consists of the airbag sensor assembly and
curtain shield airbag assembly LH.
The airbag sensor assembly uses this circuit to deploy the airbag when deployment
conditions are met.
These DTCs are stored when a malfunction is detected in the curta ...