CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
(a) Inspect the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
3. |
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Using the Techstream, check for CAN communication system DTCs.
Click here
Result |
Proceed to |
---|---|
CAN communication system DTCs are not output |
A |
CAN communication system DTCs are output |
B |
B | ![]() |
GO TO CAN COMMUNICATION SYSTEM |
|
4. |
CHECK FOR DTC* |
(a) Check for DTCs and note any codes that are output.
Click here
(b) Clear the DTCs.
Click here
(c) Recheck for DTCs. Based on the DTCs output above, try to force output of the air conditioning system DTC by simulating the operation indicated by the DTC.
Click here
Result |
Proceed to |
---|---|
DTCs are not output |
A |
DTCs are output |
B |
B | ![]() |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
5. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
Result |
Proceed to |
---|---|
Fault is not listed in Problem Symptoms Table |
A |
Fault is listed in Problem Symptoms Table |
B |
B | ![]() |
GO TO PROBLEM SYMPTOMS TABLE |
|
6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Data List / Active Test.
Click here
(b) Terminals of ECU.
Click here
(c) On-vehicle Inspection.
(d) Inspection.
|
7. |
ADJUST, REPAIR OR REPLACE |
NEXT | ![]() |
END |
Toyota CH-R Service Manual > Roof Headlining: Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL HEADLINING LIGHT CASE
(a) Align the markings on the roof headlining with the headlining light case
and install it using hot melt glue.
*a
Marking
-
-
2. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY
Click here ...
Toyota CH-R Service Manual > Pre-collision System: Front Radar Sensor Incorrect Axial Gap (C1A11,C1A14)
DESCRIPTION
When the system determines that the vehicle is driving straight ahead based on
signals from the yaw rate and acceleration sensor (airbag sensor assembly), etc.,
the millimeter wave radar sensor assembly performs self-diagnosis to check if the
sensor beam axis is misaligned.
C1A11 ...