INSTALLATION
PROCEDURE
1. INSTALL QUICK HEATER ASSEMBLY (for VALEO Made)
(a) Install the quick heater assembly with the 2 screws as shown in the illustration.
![]() |
Install in this Direction |
2. INSTALL QUICK HEATER ASSEMBLY (for DENSO Made)
(a) Engage the guide to install the quick heater assembly as shown in the illustration.
![]() |
Install in this Direction |
3. INSTALL NO. 2 HEATER COVER (for VALEO Made)
(a) Install the No. 2 heater cover with the screw. |
|
(b) Connect the connector. |
|
(c) Engage the clamp.
4. INSTALL NO. 2 HEATER COVER (for DENSO Made)
(a) Engage the guide and claw. |
|
(b) Install the No. 2 heater cover with the screw.
(c) Connect the 2 connectors. |
|
(d) Engage the clamp.
5. INSTALL NO. 1 AIR DUCT
Click here
6. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
7. INSTALL COWL SIDE TRIM BOARD LH
Click here
8. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
Toyota CH-R Service Manual > Vehicle Stability Control System: TC and CG Terminal Circuit
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the ECU to display DTCs by
blinking the ABS warning and slip indicator lights.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform system
variant learning.
Clic ...
Toyota CH-R Service Manual > Airbag System: Short in Selectable Force Limiter Squib RH Circuit (B1940/75-B1943/75)
DESCRIPTION
The selectable force limiter squib RH circuit consists of the airbag sensor assembly
and front seat outer belt assembly RH.
The airbag sensor assembly uses this circuit to deploy the pretensioner when
deployment conditions are met.
These DTCs are stored when a malfunction is detec ...