Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT COMPRESSOR WITH PULLEY ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

2 (SOL+) - 1 (SOL-)

20°C (68°F)

10.1 to 11.1 Ω

If the result is not as specified, replace the compressor with pulley assembly.

*a

Component without harness connected

(Compressor with Pulley Assembly)

    Components
    COMPONENTS ILLUSTRATION *1 COMPRESSOR WITH PULLEY ASSEMBLY *2 DISCHARGE HOSE SUB-ASSEMBLY *3 NO. 1 ENGINE UNDER COVER ...

    Removal
    REMOVAL PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (for HFC-134a(R134a)) Click here 2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (for HFO-1234yf(R1234yf)) Click here ...

    Other materials:

    Toyota CH-R Service Manual > Pre-collision System: Utility
    UTILITY NOTICE: When replacing a millimeter wave radar sensor assembly, replace it with a new one. If the millimeter wave radar sensor assembly has been replaced or removed/installed, be sure to perform Front Beam Axis Adjustment. If not performed, DTC C1A14 will be stored when the system i ...

    Toyota CH-R Service Manual > Power Window Control System: Key-off Operation Function Operates even if Operating Conditions are not Satisfied
    DESCRIPTION When the front doors are closed, each power window regulator motor assembly can be operated for approximately 45 seconds after the ignition switch is turned from ON to off by receiving operation permission signals from the main body ECU (multiplex network body ECU). However, when ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0068