Toyota CH-R Service Manual: Compressor(for Valeo Made)

Installation

INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL (a) When replacing the compressor with pulley assembly with a new one, gradually discharge the refrigerant gas from the service valve. ...

Components

COMPONENTS ILLUSTRATION *1 COMPRESSOR WITH PULLEY ASSEMBLY *2 DISCHARGE HOSE SUB-ASSEMBLY *3 NO. 1 ENGINE UNDER COVER ...

Other materials:

Toyota CH-R Service Manual > Ptc Heater Assembly: Removal
REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH Click here 2. REMOVE COWL SIDE TRIM BOARD LH Click here 3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 4. REMOVE NO. 1 AIR DUCT Click here 5. REMOVE NO. 2 HEATER COVER (for VALEO Made) ( ...

Toyota CH-R Service Manual > Occupant Detection Sensor: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the occupant detection sensor removal/installation are shown below. Necessary Procedure After Pa ...