Toyota CH-R Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL BATTERY

HINT:

Perform "clear the integrated current value", "switch battery type" after replacing the battery.

Click here

(a) Install the battery to the vehicle.

(b) Install the No. 2 battery clamp with the bolt.

Torque:

15.4 N·m {157 kgf·cm, 11 ft·lbf}

(c) Install the battery insulator to the battery.

(d) Connect the cable to the positive (+) battery terminal and engage the clamp.

(e) Tighten the nut.

Torque:

5.6 N·m {57 kgf·cm, 50 in·lbf}

(f) Engage the 2 claws and install the fusible link cover.

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

(a) Connect the cable to the negative (-) battery terminal and tighten the nut.

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

3. PERFORM INITIALIZATION

(a) Perform "clear the integrated current value", "switch battery type" after replacing the battery.

Click here

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

    3zr-fae Coolant
    ...

    Other materials:

    Toyota CH-R Service Manual > Networking: Network Gateway Ecu
    Components COMPONENTS ILLUSTRATION *1 CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU) *2 ECU INTEGRATION BOX RH Removal REMOVAL PROCEDURE 1. REMOVE NO. 2 INSTRUMENT PANEL LOWER FINISH PANEL Click here 2. REMOVE ECU INTEGRATION BOX RH ...

    Toyota CH-R Owners Manual > Steps to take in an emergency: If the vehicle battery is discharged
    The following procedures may be used to start the engine if the vehicle's battery is discharged. You can also call your Toyota dealer or a qualified repair shop. If you have a set of jumper (or booster) cables and a second vehicle with a 12-volt battery, you can jump start your vehicle b ...

    © 2017-2020 Copyright www.tochr.net
    0.0183