Toyota CH-R Service Manual: Installation

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY (a) Connect the 2 links of the blower assembly to the 2 plates of the No. 1 blower damper servo sub-assembly as ...

Blower Unit(for Valeo Made)

...

Other materials:

Toyota CH-R Owners Manual > If you have a flat tire: Installing the spare tire
1. Remove any dirt or foreign matter from the wheel contact surface. If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to come off. 2. Install the tire and loosely tighten each wheel nut by hand by approximately th ...

Toyota CH-R Service Manual > Can Communication System: Check Bus 2 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 18 (CA4H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 17 (CA4L) of the central gateway ECU (network gateway ECU) and ...