REMOVAL
PROCEDURE
1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (for HFC-134a(R134a))
Click here
2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (for HFO-1234yf(R1234yf))
Click here
3. REMOVE AIR CONDITIONER PRESSURE SENSOR (for VALEO Made)
(a) Disconnect the connector.
|
*a |
Turn |
|
*b |
Hold |
(b) Using a 27 mm deep socket wrench, remove the air conditioner pressure sensor as shown in the illustration.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
4. REMOVE AIR CONDITIONER PRESSURE SENSOR (for DENSO Made)
|
(a) Disconnect the connector. |
|
|
(b) Using a 27 mm deep socket wrench, remove the air conditioner pressure sensor as shown in the illustration. NOTICE: Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter. |
|
On-vehicle Inspection
InstallationToyota CH-R Service Manual > Outer Rear View Mirror: Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. INSTALL NO. 2 OUTER MIRROR COVER (w/ Illumination)
(a) Engage the claws to install the No. 2 outer mirror cover as shown in th ...
Toyota CH-R Service Manual > Blower Unit(for Denso Made): Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration)
that must be performed after parts are removed and installed, or replaced during
blower unit removal/installation are shown below.
Necessary Procedure After Parts Removed/Install ...