PROBLEM SYMPTOMS TABLE
HINT:
Symptom |
Suspected Area |
Link |
---|---|---|
Only wireless control function is inoperative |
Proceed to "Only wireless control function is inoperative" |
|
Only answer-back function does not operate properly |
Proceed to "No answer-back" |
|
Only automatic lock function does not operate properly |
Perform operation check |
|
Key reminder warning system |
|
|
Lighting system (front door courtesy light switch circuit) |
|
|
Lighting system (rear door courtesy light switch circuit) |
|
|
Main body ECU (multiplex network body ECU) |
- |
|
Only illuminated entry function does not operate |
Perform operation check |
|
Lighting system |
|
|
Main body ECU (multiplex network body ECU) |
- |
|
Only door ajar warning function does not operate*1 |
Perform operation check |
|
Lighting system (Door courtesy switch circuit) |
|
|
Main body ECU (Multiplex network body ECU) |
- |
|
Only panic alarm function does not operate*1 |
Perform operation check |
|
Lighting system (Int) (Interior lights) |
|
|
Lighting system (EXT) (Headlights, taillights, hazard warning lights) |
|
|
horn system |
|
|
Instrument panel junction block assembly |
- |
|
Main body ECU (Multiplex network body ECU) |
- |
|
When returning to the vehicle, although door unlock operation was not performed, doors were in an unlocked state. |
Proceed to "Improper Operation" |
|
When returning to the vehicle, although door lock operation was not performed, doors were in a locked state. |
Proceed to "Improper Operation" |
|
Toyota CH-R Service Manual > Vacuum Pump: Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE END COVER
(a) Using a T25 "TORX" socket wrench, remove the 5 screws and end cover.
NOTICE:
Hold the vacuum pump assembly so that its installation surface,
fitting parts and oil pipe will not be damaged.
As the vac ...
Toyota CH-R Service Manual > Seat Belt Warning System(w/o Occupant Classification System): Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the following table, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when deciding whether a part
is faulty or not.
HINT:
Using the Techstream to read the Data List allows ...