Toyota CH-R Service Manual: Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

Body Electrical > Smart Key > Trouble Codes

(e) Check for DTCs.

Click here

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

Body Electrical > Smart Key > Clear DTCs

(e) Clear the DTCs.

    Terminals Of Ecu
    TERMINALS OF ECU CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *A Main Body ECU (Multiplex Network Body ECU) with 2 Connecto ...

    Data List / Active Test
    DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any part ...

    Other materials:

    Toyota CH-R Service Manual > Automatic Light Control Sensor: On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Check the wire harness. (1) Disconnect the automatic light control sensor (G1). (2) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connect ...

    Toyota CH-R Service Manual > Automatic Headlight Beam Level Control System: Initialization has not been Performed (B2450)
    DESCRIPTION The headlight ECU sub-assembly LH stores this DTC if initialization has not been performed after the ECU was replaced. DTC No. Detection Item DTC Detection Condition Trouble Area Note B2450 Initializat ...

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2025 Copyright www.tochr.net
    0.0106