Components
COMPONENTS
ILLUSTRATION
|
*1 |
REAR WASHER NOZZLE |
- |
- |
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT REAR WASHER NOZZLE
(a) Operate the rear washer nozzle and check the position that the washer fluid contacts the back door glass.
Standard:
Washer fluid contacts the back door glass in the area shown in the illustration.
|
*a |
Vchicle center line |
*b |
Ceramic Line |
|
Measurement |
- |
- |
Standard Measurement:
|
Area |
Measurment |
Area |
Measurment |
|---|---|---|---|
|
A |
16.9 mm (0.665 in.) |
B |
22.5 mm (0.886 in.) |
HINT:
If the result is not as specified, replace the rear washer nozzle.
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR SPOILER ASSEMBLY
Click here
2. REMOVE REAR WASHER NOZZLE
|
(a) Disconnect the rear washer hose. |
|
(b) Disengage the claws to remove the rear washer nozzle.
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR WASHER NOZZLE
|
(a) Engage the claws to install the rear washer nozzle. |
|
(b) Connect the rear washer hose.
2. INSPECT REAR WASHER NOZZLE
Click here
3. INSTALL REAR SPOILER ASSEMBLY
Click here
Washer Nozzle(for Front Side)Toyota CH-R Service Manual > Black Out Tape(for Front Door): Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. REPAIR INSTRUCTION
(a) Clean the vehicle body surface.
(1) Using a heat light, heat the vehicle body surface.
Heating Temp ...
Toyota CH-R Owners Manual > Driving procedures: Engine (ignition) switch (vehicles without a smart key system)
Starting the engine
Check that the parking brake is set.
Check that the shift lever is in P.
Firmly depress the brake pedal.
Turn the engine switch to the "START" position to start the engine.
Changing the engine switch positions
"LOCK"
The steering wheel is lo ...