Toyota CH-R Service Manual: Rear Wiper Rubber

Installation

INSTALLATION PROCEDURE 1. INSTALL REAR WIPER MOTOR ASSEMBLY (a) Install the rear wiper motor assembly with the 3 bolts. Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} (b) Connect the connector. 2. ...

Washer Level Warning Switch

...

Other materials:

Toyota CH-R Service Manual > Continuously Variable Transaxle System: Initialization
INITIALIZATION NOTICE: Performing Reset Memory will clear the learned value of the yaw rate and acceleration sensor (deceleration sensor zero point calibration) and the CVT oil pressure (CVT oil pressure calibration). Make sure to perform Reset Memory, yaw rate and acceleration ...

Toyota CH-R Service Manual > Transponder Key Ecu: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transponder key ECU assembly removal/installation are shown below. Necessary Procedure After Pa ...