Toyota CH-R Service Manual: Inspection

Toyota CH-R Service Manual / Wiper / Washer / Front Wiper Motor / Inspection

INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Ensure that fingers or articles of clothing do not get caught in moving parts when performing this test.

PROCEDURE

1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY

(a) Check the LO operation.

(1) Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 5 (+1)

Battery negative (-) → Terminal 4 (E)

Motor operates at low speed

*a

Component without harness connected

(Windshield Wiper Motor Assembly)

(b) Check the HI operation.

(1) Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 3 (+2)

Battery negative (-) → Terminal 4 (E)

Motor operates at high speed

If the result is not as specified, replace the windshield wiper motor assembly.

    Removal
    REMOVAL CAUTION / NOTICE / HINT NOTICE: Make sure to hold the front wiper arm while lifting it as lifting the front wiper arm by the front wiper blade may damage or deform the front wiper blade. ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT NOTICE: Make sure to hold the front wiper arm while lifting it as lifting the front wiper arm by the front wiper blade may damage or deform the front wiper bl ...

    Other materials:

    Toyota CH-R Service Manual > Airbag System: Short in Rear Pretensioner Squib RH Circuit (B1920/77-B1923/77)
    DESCRIPTION The rear pretensioner squib RH circuit consists of the airbag sensor assembly and rear seat 3 point type outer belt assembly RH. The airbag sensor assembly uses this circuit to deploy the pretensioner when deployment conditions are met. These DTCs are stored when a malfunction is ...

    Toyota CH-R Service Manual > Brake Master Cylinder: Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY (a) Mount the brake master cylinder sub-assembly in a vise. NOTICE: Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly. (b) Using an T20 "TORX" socket wren ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0083