Toyota CH-R Service Manual: Diagnosis System

DIAGNOSIS SYSTEM

CHECK DLC3

(a) Check the DLC3.

Click here

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

    Terminals Of Ecu
    TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (for TMMT Made) (a) Disconnect the F72 air conditioning amplifier assembly connector. (b) Measure the voltage and resistance according t ...

    Data List / Active Test
    DATA LIST / ACTIVE TEST ACTIVE TEST HINT: Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive ...

    Other materials:

    Toyota CH-R Service Manual > Side Airbag Sensor(for Center Pillar): On-vehicle Inspection
    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to correctly follow the removal and installation procedures for the side airbag sensors. PROCEDURE 1. INSPECT SIDE AIRBAG SENSOR (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check. Click here 2. INS ...

    Toyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Engine does not Start but Initial Combustion Occurs
    DESCRIPTION If the key ID codes of the key and transponder key ECU assembly match, the immobiliser system is unset and the engine start permission signal is sent to the ECM. When the ID codes of the transponder key ECU assembly and ECM match, the engine starts. WIRING DIAGRAM CAUTION / NOTI ...

    © 2017-2019 Copyright www.tochr.net
    0.027