Toyota CH-R Service Manual: Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT DEFOGGER RELAY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 4

Battery voltage applied to terminals 1 and 2

10 kΩ or higher

3 - 4

Battery voltage not applied between terminals

Below 1 Ω

3 - 5

Battery voltage applied to terminals 1 and 2

Below 1 Ω

3 - 5

Battery voltage not applied between terminals

10 kΩ or higher

4 - 5

Always

10 kΩ or higher

If the result is not as specified, replace the defogger relay.

    Rear Power Window Switch
    Components COMPONENTS ILLUSTRATION *1 POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL *2 REAR POWER WINDOW REGULAT ...

    Window Defogger System
    ...

    Other materials:

    Toyota CH-R Service Manual > Wireless Door Lock Control System(w/ Smart Key System): Precaution
    PRECAUTION PRECAUTIONS WHEN USING Techstream (a) When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then se ...

    Toyota CH-R Service Manual > Blind Spot Monitor System: Steering Angle Sensor (C1A47)
    DESCRIPTION The blind spot monitor sensor receives steering signals from the steering sensor via CAN communication. DTC No. Detection Item DTC Detection Condition Trouble Area C1A47 Steering Angle Sensor A fail fl ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0078