INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
(a) Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly.
(b) Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
HINT:
When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY
Click here
3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY
Click here
4. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY
Click here
5. INSTALL REAR DOOR GLASS RUN
Click here
6. INSTALL REAR DOOR FRAME GARNISH
Click here
7. INSTALL REAR DOOR SERVICE HOLE COVER
Click here
8. INSTALL REAR DOOR BELT REAR SEAL
Click here
9. INSTALL REAR DOOR BELT SEAL
Click here
10. INSTALL REAR DOOR GLASS INNER WEATHERSTRIP
Click here
11. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
Click here
12. INSTALL REAR DOOR REAR FRAME BRACKET
Click here
13. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL
Click here
14. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
Click here
15. CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here
16. INITIALIZE POWER WINDOW CONTROL SYSTEM
Click here
17. INSPECT POWER WINDOW OPERATION
Click here
Inspection
Rear Power Window SwitchToyota CH-R Service Manual > Refrigerant(for Hfo-1234yf(r1234yf)): On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT REFRIGERANT PRESSURE WITH MANIFOLD GAUGE SET
HINT:
The following examples show the readings of a manifold gauge set and the corresponding
air conditioning system problems.
(a) Read the manifold gauge pressure when the following conditions are met:
...
Toyota CH-R Service Manual > Lighting System: Taillight Relay Circuit
DESCRIPTION
The main body ECU (multiplex network body ECU) controls the operation of the
TAIL relay.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing
the following procedure.
Before replacing the main body ...