Toyota CH-R Service Manual: Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT FOG FR RELAY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 5

Battery voltage not applied between terminals 1 and 2

10 kΩ or higher

3 - 5

Battery voltage applied between terminals 1 and 2

Below 1 Ω

If the result is not as specified, replace the fog FR relay.

2. INSPECT HEADLIGHT DIMMER RELAY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 5

Battery voltage not applied between terminals 1 and 2

10 kΩ or higher

3 - 5

Battery voltage applied between terminals 1 and 2

Below 1 Ω

If the result is not as specified, replace the headlight dimmer relay.

    Rear Turn Signal Light Bulb
    Components COMPONENTS ILLUSTRATION *1 REAR COMBINATION LIGHT ASSEMBLY *2 REAR COMBINATION LIGHT COVER *3 REAR TURN SIGNAL ...

    Side Turn Signal Light Assembly
    Components COMPONENTS ILLUSTRATION *1 OUTER MIRROR COVER *2 SIDE TURN SIGNAL BULB *3 SIDE TURN SIGNAL LIGHT ASSEMBLY ...

    Other materials:

    Toyota CH-R Service Manual > Vacuum Warning Switch: Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during vacuum warning switch assembly removal/installation are shown below. Necessary Procedure After Part ...

    Toyota CH-R Service Manual > Front Brake: Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE FRONT DISC BRAKE PISTON (a) Place a piece of cloth between the front disc brake piston and front disc brake cylinder assembly. *a Cloth ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0064