Toyota CH-R Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL REAR COMBINATION LIGHT ASSEMBLY

(a) Connect the connector.

(b) Engage the guide, pin and clip to temporarily install the rear combination light assembly as shown in the illustration.

Install in this Direction

(c) Install the rear combination light assembly with the 2 screws.

(d) Remove the protective tape.

2. INSTALL REAR COMBINATION LIGHT COVER

(a) Engage the claws to install the rear combination light cover as shown in the illustration.

Install in this Direction

    Inspection
    INSPECTION PROCEDURE 1. INSPECT REAR COMBINATION LIGHT ASSEMBLY LH (a) Apply battery voltage to the rear combination light assembly LH and check that the light comes on. OK: ...

    Rear Light Assembly(for Bulb Type)
    Components COMPONENTS ILLUSTRATION *1 BACK UP LIGHT BULB *2 REAR LIGHT ASSEMBLY *3 REAR LIGHT PACKING *4 ...

    Other materials:

    Toyota CH-R Service Manual > Rear Stabilizer Bar: Installation
    INSTALLATION PROCEDURE 1. INSTALL REAR STABILIZER BUSHING (a) Install the 2 rear stabilizer bushings to the rear stabilizer bar. NOTICE: Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle. 2. INSTALL REAR NO. 1 STABILIZER BAR BRACKET (a) Insta ...

    Toyota CH-R Service Manual > Airbag System: Short in Driver Side Knee Airbag Squib Circuit (B1860/64-B1863/64)
    DESCRIPTION The driver side knee airbag squib circuit consists of the airbag sensor assembly and lower No. 1 instrument panel airbag assembly. The airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs are stored when a malfunction is dete ...

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    KIA Niro EV / Hybrid (SG2) - (2021-2023) - Owner's manual

    © 2017-2023 Copyright www.tochr.net
    0.013