REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE
|
(a) Connect the connector. |
|
(b) Engage the clamp to install the rear combination light socket and wire.
2. INSTALL REAR SIDE MARKER LIGHT BULB
(a) Install the rear side marker light bulb to the rear combination light socket and wire.
|
Install in this Direction |
(b) Turn the rear combination light socket and wire with the rear side marker light bulb as shown in the illustration to connect them as a unit.
|
Install in this Direction |
3. INSTALL REAR TURN SIGNAL LIGHT BULB
(a) Install the rear turn signal light bulb to the rear combination light socket and wire.
|
Install in this Direction |
(b) Turn the rear combination light socket and wire with the rear turn signal light bulb as shown in the illustration to connect them as a unit.
|
Install in this Direction |
4. INSTALL REAR COMBINATION LIGHT LED
(a) Turn the rear combination light LED as shown in the illustration to install it.
|
Install in this Direction |
(b) Install the screw.
(c) Connect the connector.
Disassembly
InstallationToyota CH-R Owners Manual > Dynamic radar cruise control with full-speed range: Driving in vehicle-to-vehicle distance control mode
This mode employs a radar sensor to detect the presence of vehicles up to approximately
328 ft. (100 m) ahead, determines the current vehicle-to-vehicle following distance,
and operates to maintain a suitable following distance from the vehicle ahead.
Note that vehicle-to-vehicle distance will ...
Toyota CH-R Service Manual > Navigation System: Cursor or Map Rotates when Vehicle Stopped
PROCEDURE
1.
CHECK CONDITION
(a) Check with the customer if the vehicle has been turned by a turntable.
OK:
Vehicle has not been turned by a turntable.
HINT:
If the vehicle is turned on a turntable with the engine switch on (IG),
the syst ...