Toyota CH-R Service Manual: Disassembly

Toyota CH-R Service Manual / Lighting (ext) / Rear Combination Light Assembly(for Bulb Type) / Disassembly

DISASSEMBLY

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE REAR COMBINATION LIGHT LED

(a) Disconnect the connector.

Remove in this Direction

(b) Remove the screw.

(c) Turn the rear combination light LED as shown in the illustration to remove it.

2. REMOVE REAR TURN SIGNAL LIGHT BULB

(a) Turn the rear combination light socket and wire with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.

Remove in this Direction

(b) Remove the rear turn signal light bulb from the rear combination light socket and wire.

Remove in this Direction

3. REMOVE REAR SIDE MARKER LIGHT BULB

(a) Turn the rear combination light socket and wire with the rear side marker light bulb as shown in the illustration to disconnect them as a unit.

Remove in this Direction

(b) Remove the rear side marker light bulb from the rear combination light socket and wire.

Remove in this Direction

4. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE

(a) Disengage the clamp.

(b) Disconnect the connector to remove the rear combination light socket and wire.

    Removal
    REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE REAR COMBINATION LIGHT ...

    Reassembly
    REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL REAR COMBINATION LI ...

    Other materials:

    Toyota CH-R Service Manual > Front Seat Outer Belt Assembly: On-vehicle Inspection
    ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to correctly follow the removal and installation procedures for the front seat outer belt assembly. PROCEDURE 1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check ...

    Toyota CH-R Service Manual > Vehicle Stability Control System: Yaw Rate Sensor Output Value (C1448)
    DESCRIPTION The yaw rate and acceleration sensor is built into the airbag sensor assembly. The skid control ECU receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via CAN communication. The airbag sensor assembly has a built-in yaw rate and acceleration sensor a ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0079