REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE REAR COMBINATION LIGHT COVER
(a) Disengage the claws to remove the rear combination light cover as shown in the illustration.
|
Remove in this Direction |
2. REMOVE REAR COMBINATION LIGHT ASSEMBLY
(a) Apply protective tape around the rear combination light assembly as shown in the illustration.
|
Protective Tape |
(b) Remove the 2 screws.
(c) Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the clip, guide and pin to separate the rear combination light assembly.
NOTICE:
To prevent the rear combination light assembly from falling when disengaging the pins and guides, lightly hold the rear combination light assembly.
|
*a |
Guide |
|
*b |
Pin |
|
Remove in this Direction |
|
(d) Disconnect the connector to remove the rear combination light assembly. |
|
Components
DisassemblyToyota CH-R Owners Manual > Dynamic radar cruise control with full-speed range: Changing the vehicle-to-vehicle distance (vehicle-to-vehicle distance
control mode)
Pressing the switch changes the vehicle-to-vehicle distance as follows:
Long
Medium
Short
The vehicle-to-vehicle distance is set automatically to long mode when the engine
switch is turned to the "ON" position (vehicles without a smart key system) or IGNITION
ON mode (vehicl ...
Toyota CH-R Service Manual > Curtain Shield Airbag Assembly: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
curtain shield airbag assembly removal/installation are shown below.
Necessary Procedure After ...