INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL REAR COMBINATION LIGHT ASSEMBLY
(a) Connect the connector.
(b) Engage the guide, pin and clip to temporarily install the rear combination light assembly as shown in the illustration.
|
*a |
Guide |
|
*b |
Pin |
|
Install in this Direction |
(c) Install the rear combination light assembly with the 2 screws.
(d) Remove the protective tape.
2. INSTALL REAR COMBINATION LIGHT COVER
(a) Engage the claws to install the rear combination light cover as shown in the illustration.
|
Install in this Direction |
ReassemblyToyota CH-R Service Manual > Vehicle Stability Control System: System Diagram
SYSTEM DIAGRAM
Transmitting ECU (Transmitter)
Receiving ECU
Signal
Communication Method
Skid control ECU (brake actuator assembly)
Steering angle sensor
Steering angle sensor request signal
CAN ...
Toyota CH-R Service Manual > Continuously Variable Transaxle Assembly(when Using The Engine Support Bridge): Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
continuously variable transaxle assembly removal/installation are shown below.
Necessary Proced ...