Toyota CH-R Service Manual: Diagnosis System

DIAGNOSIS SYSTEM

DESCRIPTION

(a) Lighting system data and Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.

CHECK DLC3

(a) Check the DLC3.

Click here

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

DIAGNOSIS SYSTEM (for LED Headlight)

(a) If the lighting system malfunctions, "Headlight System Malfunction Visit Your Dealer" warning message is displayed on the multi-information display.

HINT:

In this case, the headlight ECU sub-assembly LH stores DTCs.

Click here

    Terminals Of Ecu
    TERMINALS OF ECU *A Main Body ECU (Multiplex Network Body ECU) with 2 Connectors - - *1 Main Body ECU (Multiplex Network Body ...

    Dtc Check / Clear
    DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Main body / Tr ...

    Other materials:

    Toyota CH-R Service Manual > Pre-collision System: Yaw Rate Sensor (C1A46)
    DESCRIPTION The millimeter wave radar sensor assembly receives yaw rate and acceleration sensor (airbag sensor assembly) signals from the airbag sensor assembly and skid control ECU (brake actuator assembly) via CAN communication. If the millimeter wave radar sensor assembly receives yaw rate ...

    Toyota CH-R Service Manual > Rear Bumper: Removal
    REMOVAL PROCEDURE 1. REMOVE REAR BUMPER SIDE SEAL LH (a) Remove the 7 clips and rear bumper side seal LH. 2. REMOVE REAR BUMPER SIDE SEAL RH HINT: Use the same procedure as for the LH side. 3. SEPARATE QUARTER OUTSIDE MOULDING LH (a) ...

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2025 Copyright www.tochr.net
    0.0105