Toyota CH-R Service Manual: Initialization

INITIALIZATION

HEADLIGHT ECU SUB-ASSEMBLY LH INITIALIZATION (for LED Headlight)

NOTICE:

  • If any of the work in the table below has been performed, vehicle information registration and initialization of the headlight ECU sub-assembly LH are necessary.

    Performed Work or System Condition

    Necessary Procedures

    Link

    Replacement of the headlight ECU sub-assembly LH

    Vehicle information registration for the headlight ECU sub-assembly LH

    Initialization of the headlight ECU sub-assembly LH

    Work that changes the vehicle height such as replacement or removal/installation of the rear height control sensor sub-assembly LH or replacement of suspension components

    Initialization of the headlight ECU sub-assembly LH

  • A new headlight ECU sub-assembly LH cannot operate until the vehicle information is registered.
  • After replacing the headlight ECU sub-assembly LH, it is necessary to register the vehicle information and then perform initialization.
  • Even if the headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.
    Customize Parameters
    CUSTOMIZE PARAMETERS CUSTOMIZE LIGHTING SYSTEM (EXT) NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Be sure to make ...

    Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to Registration.*1 Click here If the headlight ECU sub-assembly LH ...

    Other materials:

    Toyota CH-R Service Manual > Vehicle Stability Control System: Open or Short in Brake Pedal Load Sensing Switch (C1429)
    DESCRIPTION The brake pedal load sensing switch turns on when the brake pedal is depressed with a force exceeding a predetermined level. The skid control ECU uses this circuit to detect if the brake pedal is depressed or not. DTC No. Detection Item DTC Detecti ...

    Toyota CH-R Service Manual > Front Bumper: Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE RADIATOR GRILLE Click here 2. REMOVE FRONT BUMPER EXTENSION LH (a) Disengage the claws and guide to remove the front bumper extension LH. 3. REMOVE FRONT BUMPER EXTENSION RH HINT: Use the same ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0076