Toyota CH-R Service Manual: Removal

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Check the wire harness. (1) Disconnect the automatic light control sensor (G1). (2) Measure the voltage ac ...

Installation

INSTALLATION PROCEDURE 1. INSTALL AUTOMATIC LIGHT CONTROL SENSOR (a) Engage the claws to install the automatic light control sensor. (b) ...

Other materials:

Toyota CH-R Service Manual > Outer Rear View Mirror Glass: Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE OUTER MIRROR (a) Apply protective tape to the area as shown in the illustration. Protective Tape ...

Toyota CH-R Service Manual > Pre-collision System: ECU Power Source Circuit
DESCRIPTION This circuit supplies power to the millimeter wave radar sensor assembly when the ignition switch is ON. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following inspection procedure. PROCEDURE ...