Toyota CH-R Service Manual: Components

Automatic Light Control Sensor

...

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Check the wire harness. (1) Disconnect the automatic light control sensor (G1). (2) Measure the voltage ac ...

Other materials:

Toyota CH-R Service Manual > Blower Unit(for Valeo Made): Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the blower unit removal/installation are shown below. Necessary Procedure After Parts Removed/Insta ...

Toyota CH-R Service Manual > Side Airbag Sensor(for Front Door): Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL DOOR SIDE AIRBAG SENSOR (a) Check that the ignition switch off. (b) Check that the cable is disconnected from the n ...