PROBLEM SYMPTOMS TABLE
NOTICE:
*1: w/ Smart Key System
Click here
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Automatic High Beam System|
Symptom |
Suspected Area |
Link |
|---|---|---|
|
Automatic high beam indicator on the combination meter assembly does not illuminate |
Check operating conditions |
|
|
Check meter / gauge system |
|
|
|
Automatic high beam switch circuit |
|
|
|
Headlight dimmer switch circuit |
|
|
|
Combination meter assembly |
|
|
|
Forward recognition camera |
|
|
|
Main body ECU (Multiplex network body ECU) |
|
|
|
Automatic high beam system does not operate |
Check operating conditions |
|
|
Check Data List (Auto H Beam STS) |
|
|
|
Check that the low beams and high beams operate manually |
- |
|
|
Check automatic light control system operation |
|
|
|
Automatic high beam switch circuit |
|
|
|
Headlight dimmer switch circuit |
|
|
|
Forward recognition camera power source circuit |
|
|
|
Forward recognition camera |
|
|
|
Main body ECU (Multiplex network body ECU) |
|
Operation Check
Terminals Of EcuToyota CH-R Service Manual > Brake Fluid: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR
(a) Check the fluid level.
If brake fluid level is lower than the MIN line, check for leaks and
inspect the disc brake pads. If necessary, refill the reservoir with brake
fluid to the MAX line after re ...
Toyota CH-R Service Manual > Hood: Reassembly
REASSEMBLY
PROCEDURE
1. CONNECT WASHER HOSE ASSEMBLY
(a) Install the 7 clamps.
(b) Connect the washer hose assembly to the clamps and guide.
*a
...