DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE NO. 1 BODY OUTSIDE MOULDING PAD
(a) Remove the No. 1 body outside moulding pad (double-sided tape).
HINT:
Do not pull on No. 1 body outside moulding pad (double-sided tape). Instead, roll the tape up with your finger to remove it cleanly.
(b) Using non-residue solvent and a cloth, wipe off any No. 1 body outside moulding pad (double-sided tape) remaining on the quarter outside moulding sub-assembly.
Removal
ReassemblyToyota CH-R Service Manual > Rear Brake(for Tmc Made): Reassembly
REASSEMBLY
PROCEDURE
1. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG
(a) Temporarily install the rear disc brake bleeder plug to the rear disc brake
cylinder assembly.
HINT:
Fully tighten the rear disc brake bleeder plug after bleeding the system.
2. INSTALL REAR DISC BRAKE BLEEDER PLUG ...
Toyota CH-R Service Manual > Rear Combination Light Assembly(for Bulb Type): Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR COMBINATION LIGHT COVER
(a) Disengage the claws to remove the rear combination light cover as shown in
the illustra ...