Toyota CH-R Service Manual: Removal

Toyota CH-R Service Manual / Exterior Panels / Trim / Wheel Opening Moulding(for Rear) / Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE QUARTER OUTSIDE MOULDING

HINT:

When removing the quarter outside moulding, if the No. 1 body outside moulding pad (double-sided tape) is difficult to remove, heat the adhesive of the quarter outside moulding using a heat light.

Standard:

Item

Temperature

Quarter Outside Moulding

20 to 30°C (68 to 86°F)

CAUTION:

  • Do not touch the heat light and heated parts, touching the heat light may result in burns.

    *a

    Heated Part

    *b

    Heat Light
  • Touching heated parts for a long time may result in burns.

NOTICE:

Do not heat the quarter outside moulding excessively.

(a) Remove the 3 screws and clip.

(b) Apply protective tape around the quarter outside moulding.

Protective Tape

(c) Disengage the claws by pushing the area indicated by the arrow in the illustration with a finger.

Place Hand Here

Remove in this Direction (1)

Remove in this Direction (2)

NOTICE:

To avoid damaging the claws, do not forcibly pull the quarter outside moulding.

(d) Disengage the clips and separate the double-sided tape to remove the quarter outside moulding.

*1

No. 1 Body Outside Moulding pad (Double-sided Tape)

-

-

Place Hand Here

Remove in this Direction
    Components
    COMPONENTS ILLUSTRATION *1 QUARTER OUTSIDE MOULDING - - ILLUSTRATION *1 NO. 1 BODY OUTSIDE MOULDING PAD - ...

    Disassembly
    DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE NO. 1 BODY OUTSIDE M ...

    Other materials:

    Toyota CH-R Owners Manual > Tire information: Uniform Tire Quality Grading
    This information has been prepared in accordance with regulations issued by the National Highway Traffic Safety Administration of the U.S. Department of Transportation. It provides the purchasers and/or prospective purchasers of Toyota vehicles with information on uniform tire quality grading. ...

    Toyota CH-R Service Manual > Generator: Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE GENERATOR PULLEY CAP (a) Using a screwdriver, remove the generator pulley cap from the generator pulley with clutch. NOTICE: Do not reuse the generator pulley cap. 2. REMOVE GENERATOR PULLEY WITH ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0116