Toyota CH-R Service Manual: Installation

Toyota CH-R Service Manual / Exterior Panels / Trim / Quarter Garnish / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL QUARTER PILLAR COVER SUB-ASSEMBLY

HINT:

When installing a new quarter pillar cover sub-assembly, heat the vehicle body and quarter pillar cover sub-assembly using a heat light.

CAUTION:

  • Do not touch the heat light and heated parts, touching the heat light may result in burns.
  • Touching heated parts for a long time may result in burns.

*a

Heated Part

*b

Heat Light
Heating Temperature

Item

Temperature

Vehicle Body

40 to 60°C (104 to 140°F)

Quarter Pillar Cover Sub-assembly

20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the vehicle body or quarter pillar cover sub-assembly excessively.

(a) Clean the vehicle body surface.

(1) Using a heat light, heat the vehicle body surface.

(2) Remove any double-sided tape from the vehicle body.

(3) Wipe off any tape adhesive residue with cleaner.

(b) Remove the release paper from a new quarter pillar cover sub-assembly.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.

(c) Engage the guide and clips to install the quarter pillar cover sub-assembly as shown in the illustration.

*a

Double-sided Tape

Install in this Direction

HINT:

When installing the double-side tape, peel off the backing paper.

(d) Press the quarter pillar cover sub-assembly.

    Disassembly
    DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. REMOVE QUARTER GARNISH MOU ...

    Reassembly
    REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL QUARTER GARNISH MOU ...

    Other materials:

    Toyota CH-R Service Manual > Audio And Visual System(for Radio And Display Type): Noise Occurs
    PROCEDURE 1. CHECK NOISE CONDITION (a) Check from which direction the noise comes (front left or right, or rear left or right). OK: The location of the noise source can be determined. NG GO TO STEP 3 OK ...

    Toyota CH-R Service Manual > Wiper Switch: Inspection
    INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Front Wiper Switch Tester Connection Condition Specified Condition ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0065