Replace the battery with a new one if it is depleted.
You will need the following items:
Vehicles without a smart key system: CR1620
Vehicles with a smart key system: CR2032
Replacing the battery
Vehicles without a smart key system
1. Remove the cover.
To prevent damage to the key, cover the tip of the screwdriver with a rag.
2. Remove the battery cover.
3. Remove the depleted battery using a small flathead screwdriver.
Insert a new battery with the "+" terminal facing up.
4. When installing, reverse the steps listed.
Vehicles with a smart key system
1. Release the lock and take out the mechanical key.
2. Remove the cover.
Use an appropriate sized flathead screwdriver. Forceful prying may deform the cover.
To prevent damage to the key, cover the tip of the screwdriver with a rag.
3. Remove the depleted battery.
When removing the cover, if the battery cannot be seen due to the electronic key module attaching to the upper cover, remove the electronic key module from the cover so that the battery is visible as shown in the illustration.
Use an appropriate sized flathead screwdriver when removing the battery.
Insert a new battery with the "+" terminal facing up.
4. When installing, reverse the steps listed.
■Use a CR1620 (vehicles without a smart key system) or CR2032 (vehicles with a smart key system) lithium battery
■If the key battery is depleted The following symptoms may occur:
■Removed battery and other parts These parts are small and if swallowed by a child, they can cause choking.
Keep away from children. Failure to do so could result in death or serious injury.
■For normal operation after replacing the battery Observe the following precautions to prevent accidents:
Moisture may cause the battery to rust.
Toyota CH-R Service Manual > Continuously Variable Transaxle System: Brake ECU Malfunction (P1750)
DESCRIPTION
HINT:
This DTC P1750 is applicable to Mexico models only.
When the ECM receives a malfunction signal from the skid control ECU (brake actuator
assembly), DTC P1750 is stored.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
...
Toyota CH-R Service Manual > Vehicle Stability Control System: TRAC does not Operate
DESCRIPTION
When ABS, TRAC or VSC is operating, the skid control ECU (brake actuator assembly)
blinks the slip indicator light to inform the driver that slippage occurred.
When in VSC off mode, or TRAC and VSC are disabled, the multi-information display
in the combination meter assembly displa ...